Tuesday, August 23, 2022

RasPi Eyesy Clone - Part 2 : The Case

 


Almost pulled my hair out measuring everything out for the AudioInjector-on-the-Pi case... This is what I have now, will try to print it later this week, see if it works. I need to add some sort of venting on it because the Pi4 runs pretty hot. I think it will be an answer for all of those on the AudioInjector forums. Because measuring this out 3 or 4 times to make sure its correct was a pain. I really hope it all lines up....



at
Labels: , , ,

No comments:

Post a Comment

Don't be a dingus

Subscribe to: Post Comments (Atom)

StreamElements Overlay Chat - Top Down display!

 Okay, this seems silly to make a post like this, but I wish I had found a page that told me this before wasting a few hours trying to figur...

  • DIY "StreamDeck"
     OK, so it's far from being an ACTUAL StreamDeck, but here's what I did to make a old external 10-key Numpad with PS/2 plug into a k...
  • Raspberry Pi 4 Eyesy Clone Guide
    Raspberry Pi 4 "Eyesy" Clone  Using a Raspberry Pi 4, MIDI, and an AudioInjector Opening Note This is pretty much the same thing y...
  • RasPi Eyesy Clone - Part 2 : The Case
      Almost pulled my hair out measuring everything out for the AudioInjector-on-the-Pi case... This is what I have now, will try to print it l...